News

Specializing in the development, production, sales and service of semiconductor thermoelectric cooling engineering products

What is the process of installation of semiconductor cooling tablets

Release time:

2022-11-28


  Semiconductor refrigeration sheet as a device with excellent performance must be no stranger to it, so you know the semiconductor refrigeration sheet in the installation of the process are what? The following letHangzhou semiconductor cooling chipWe'll explain it to you!

One, we will tear off the tape side of the purchased thermal pad, paste it on the radiator, align the two screw holes, and press hard without leaving a gap. The stronger the better.

Second, we apply a thin layer of thermally conductive silicone grease to the hot end of the semiconductor cooling chip TEC1-12706 (usually the side with the text), which can no longer be coated, and place it on the heat sink (do not press it first). Then apply a layer of thermally conductive silicone grease on the cold end so that you can see the picture below.

Third, we put the cooling plate on the cooling plate in the previous step, align with the screw holes and press gently. Be sure to lightly press, do not press hard, otherwise it will be counterproductive.

Fourth, according to the size of the hole to tighten the two screws. When it is time to tighten, be careful to tighten them side by side, not all at once. As long as it fits, do not use too much force to avoid crushing the refrigeration piece. If the refrigeration piece is crushed, all our previous efforts will go down the drain.

V. The wiring is complete. The voltage should not exceed 13 V. Generally speaking, dew will be generated in one or two minutes and frost will be generated in ten minutes.

The above five points are for the semiconductor refrigeration tablets in the installation of the process related to the introduction, then this article ends here, thank you for reading!